I noticed this evening that Cumulus stated there was an error reading data
from my N96FY Fineoffset base staion and that I should disconnect the USB
cable and take the batteries out to reset the console. Which I have done
as well as rebooting my laptop.
FYI
I have spike removal settings set for rain rate to prevent spurious values.
The problem now is that I am getting the following error every minute:
06/10/2014 22:12:00 : Ignoring high hourly rain: 119.40mm
06/10/2014 22:13:00 : Ignoring high hourly rain: 119.40mm
06/10/2014 22:14:00 : Ignoring high hourly rain: 119.40mm
06/10/2014 22:15:00 : Ignoring high hourly rain: 119.40mm
06/10/2014 22:16:00 : Ignoring high hourly rain: 119.40mm
06/10/2014 22:17:00 : Ignoring high hourly rain: 119.40mm
06/10/2014 22:18:00 : Ignoring high hourly rain: 119.40mm
06/10/2014 22:19:00 : Ignoring high hourly rain: 119.40mm
and it won't stop showing these errors.
I have removed the batteries in the base console and disconnected the USB
cable and rebooted my laptop three times now and each time when Cumulus
starts up it starts showing these erronous 119.40mm hourly rain figures.
Does anyone know how I can stop this as it's driving me mad?

Any help would be appreciated.
Regards
Mark